eNodeB Monitoring with Zabbix

You are here:
< All Topics

This guide will explain how to use Zabbix for monitoring LabKits/SatSites.

Note: If Zabbix and eNodeB are not already configured , please refer to LabKit/SatSite Monitoring with Zabbix – Basic Configurations

Monitoring eNodeB with Zabbix will offer:

  • Critical 3 triggers:
    • When S1AP link is down
    • When the application restarted
    • When the Basestation is down
  • Unmet demands Showing when the network was unable to meet the demands of UEs/MSs with an indication of the cause.
  • Performance report Showing the speed and the throughput of the network.

Monitoring Triggers

From Zabbix frontend, navigate to Monitor -> problems to see list of the triggers.

S1AP Link Down

When the link is detected to be down a trigger called S1AP Disconnected will appear with high severity.

When the link is detected to be recovered , the trigger will be marked as resolved and auto clear the severity.

Basestation Stopped

When the Basestation stops, will show a trigger named Basestation Stopped with high severity.

when the Basestation is up again, the trigger will be auto resolved and the severity will be cleared.

Application Restarted

When Yate-sdr service restarts it will show a trigger named Yate-sdr service restarted with average severity which will automatically clears itself after successful restart.

Monitoring Unmet Demands

Unmet demands shows some indications that UEs are failing to connect or to use the network resources. It meant to give an idea where the problem is happening and how dangerous its affecting the network. This graph is to give a clue of the problem and cannot be used for troubleshooting.

From Zabbix frontend, navigate to Monitor -> Graphs -> Select Group/ host -> Select Basestation Unmet Demands graph from the drop down menu.

The graph will show:

  1. Unanswered paging: Shows the number of paging messages dropped without transmission by the eNodeB
  2. E-RAP failed attempts: Shows the number of failed attempts while establishing Random Access Procedure.
  3. low PHRdB: Low power headroom which indicates the UEs are using too much power.
  4. Percentage of the difference between msg3 and prachs: The percentage of uncompleted connection due to not answering RRC Connection Request (msg3)
  5. Loss rate for uplink and downlink: Lost packets for uplink and downlink
Note: The UL loss rate item is initially returned as percentage (UL packet loss rate in percent x100) according to 3GPP Section 4.4.4.2. In the template the item is divided by 100 for compatibility with the other items in the graph.

Monitoring Performance reports

From Zabbix frontend, navigate to Monitor -> Graphs -> Select Group/ host -> Select Basestation Speed or Basestation Throughput from the drop down menu.

Speed

Speed report is represented with a graph, showing the bit rate.

Throughput

Speed report is represented with a graph, showing uplink and downlink throughput

Table of Contents